 |
Most viewed |
 |
|
|
Dave and Cathie1249 viewsOur gracious hosts!
|
|
Am-Bush and Ram-Bush989 viewsGhilley suits galore!
|
|
Stuart's S-7TE's940 viewsA close up of some new equipment!
|
|
Phil, Bob, Marc and Doug924 viewsLT-SCO (Southern California Ops) representin'.
|
|
Brian and Marc916 viewsGhilley and ACU Digital... which is your preferred combat-wear?
|
|
Ring on TMB with NICE Scope885 views
|
|
Stuart's new toys858 viewsHere we see the Stuart enjoying some new "Pro" gear. Bubba to the left, Brian (rear left) and Doug Ross (rear right) enjoying those crazy getups!
|
|
Rental Water Fountain740 views$5 rental from 1sourcelasertag.com
|
|
|
|
|
Last additions |
|
|
|
3 viewsApr 16, 2012
|
|
2 viewsApr 16, 2012
|
|
16 viewsApr 16, 2012
|
|
2 viewsApr 16, 2012
|
|
6 viewsApr 16, 2012
|
|
10 viewsApr 16, 2012
|
|
6 viewsApr 16, 2012
|
|
3 viewsApr 16, 2012
|
|
|
|
|
Last viewed |
|
|
|
Phil, Bob, Marc and Doug924 viewsLT-SCO (Southern California Ops) representin'.May 20, 2012 at 08:18 AM
|
|
Am-Bush and Ram-Bush989 viewsGhilley suits galore!May 19, 2012 at 11:35 PM
|
|
16 viewsMay 19, 2012 at 11:35 PM
|
|
Adding the main Power Lines71 viewsHere you can see that I've added the main power lines. 1 - Black wire from the power supply (battery) negative (-) gnd, to hole X1. 2. Red wire from power supply (battery) posative (+) gnd, to hole Y1. 3. Finally a red wire from the output of the regulator is soldered to hole B3, over to our boards power line at hole Y1. At this point we can attach power and use a multimeter to see 5Vdc on the main power trace lines X & Y.May 19, 2012 at 12:27 PM
|
|
CSBOA quick Layout94 viewsHere is the simple layout using the 170 PCB. I've put the voltage regulator at the top left of the board and put sockets for 3 Quad Op Amp Chips which we will add after we have soldered in a few componenets.
May 19, 2012 at 04:33 AM
|
|
Dave and Cathie1249 viewsOur gracious hosts!May 18, 2012 at 06:10 PM
|
|
Stuart's S-7TE's940 viewsA close up of some new equipment!May 18, 2012 at 01:05 PM
|
|
6 viewsMay 18, 2012 at 10:25 AM
|
|
|
|
|
